Remote-processing RPC-2350 Manuale Utente Scaricare il pdf (Pagina 8)

SETUP AND OPERATION CHAPTER 2

2-2

Requirements for uploading and downloading programs

are discussed. A " Where to go from here" section

directs you to the chapters to read to use the various

capabilities of the RPC-2350 F inally, a troubleshooting

section helps on the most common problems.

OPERATING PRECAUTIONS

The RPC-2350 is designed to handle a wide temperature

range and operating conditions. These characteristics

require using CM OS com ponents. CM OS are static

sensitive. To avoid damaging these c omponents,

observe the following precautions before handling the

RPC-2350.

1. Ground yourself before handling the RPC -2350

or plugging in cables. Static electricity can

easily arc through cables and to the card.

Simply touching a metal part on your PC can

greatly reduce static.

2. Do not insert or remove components when

power is applied. While the ca rd is a + 5 volt

only system, other voltages are generated on

the card.

EQUIPMENT

You will need the following equipment to begin using the

RPC-2350:

RPC-2350 embedded controller

A PC with a serial port and communications

program

VTC -9 serial cable

+ 5, 300 mA. pow er supply or

7 to 30V applied to “7-30V” terminal on P2.

Do not connect any accessory com ponents, such as a

display or keypad, to the board until you are sure the

board w orks in you r environment.

The CAMBA SIC Programming Manual is strongly

recommended. It can be downloaded free at our web

site (www.rp3.com). Refer to Chapter 4 Serial Ports

for wiring information to make your own cable.

COMMUNICATION PROGRAM

A terminal program is used to talk with the RPC-2350

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 82 83

Nessun commento

Remote-processing RPC-2350 Manuale Utente Pagina 8